Right Door Set Sensor Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units

1.2.8 Right Door Set Sensor Removal

1. Remove the tension spring hooked to the gear 31T.
2. Remove two screws (3704) securing the PWB-A board bracket to
the Double Cassette Unit Frame and remove the bracket. (See
Section 1.2.7.)
3. Remove the screw (3501) securing the plate spring to the bracket
and remove the plate spring from the bracket.
4. Remove the following screws:


Two screws (3704) securing the solenoid bracket to the Double
Cassette Unit Frame.


Four screws (3704) securing the Paper Take-up Mechanism
(including the axle plate, guide plate, and bracket) to the 2nd
Cassette Frame.


The screw (3501) securing the rail and axle plate.
5. Lift up the Paper Take-up Solenoid and bracket.
6. Remove two screws (3501) securing the solenoid bracket to the
Paper Take-up mechanism and remove the solenoid bracket.
7. Remove the stopper securing the Right Door Set Sensor to the
solenoid bracket.
8. Release the hook fixing the Right Door Set Sensor to the solenoid
bracket and remove the sensor.
9. Disconnect the harness from the connector on the Right Door Set
Sensor.
Double Cassette Unit Disassembly and Assembly of the Double Cassette Unit
Figure 1-12. Right Door Set Sensor Removal
Revision A
15