Bin 1 Shift Home Position Sensor (Pc4) Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units

4.2.13 Bin 1 Shift Home Position Sensor (PC4) Removal

1. Remove the Front Cover and the Rear Cover. (Refer to Section
4.2.1 and Section 4.2.2.)
2. Remove the Jammed Paper Remove Door. (Refer to Section 4.2.3.)
3. Remove the Transfer Switch Solenoid. (Refer to Section 4.2.11.)
4. Remove two screws (3501 and 4005) securing the bracket for the
Paper Guide Drive Motor to the Unit Frame and remove the motor
along with the bracket. (Refer to Section 4.2.10.)
5. Remove five screws (4005 x 2 and 3501 x 3) securing the guide
plate located at the bottom of the 5-Bin Unit to the Unit Frame and
remove the guide plate. (Refer to Section 4.2.12.)
6. Remove the stopper attaching the Bin 1 Shift Home Position Sensor
to the Unit Frame.
7. Unhook the Bin 1 Shift Home Position Sensor from the Unit Frame.
8. Disconnect the harness from the connector on the Bin 1 Shift Home
Position Sensor.
5-Bin Unit Disassembly and Assembly of the 5-Bin Unit
Figure 4-23. Bin 1 Shift Home Position Sensor Removal
Revision A
88