Sorter Set Switch (S1) Removal; Controller Board (Pwb-A) Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units

5.2.2.3 Sorter Set Switch (S1) Removal

1. Remove the Rear Cover. (See Section 5.2.1.)
2. Open the cable clamp on the sorter set switch holder and remove
the harness.
3. Remove two screws (4005) securing the Sorter Set Switch to the
10-Bin Unit Frame along with the holder and bracket and remove
the holder and bracket.
4. Unhook the Sorter Set Switch from the holder and remove the
switch.
5. Disconnect the harness for the Sorter Set Switch from the connector
on the switch.
Figure 5-27. Sorter Set Switch (S1) Removal
10-Bin Unit

5.2.2.4 Controller Board (PWB-A) Removal

1. Remove the Rear Cover. (See Section 5.2.1.)
2. Remove harnesses from the connectors on the PWB-A.
NOTE: When removing the parts such as Vertical Transport Roller,
3. Unhook four PWB Supports securing the PWB-A to the bracket and
Disassembly and Assembly of the 10-Bin Unit
remove four screws (4005) and remove the bracket along
with the PWB-A.
remove the PWB-A.
Figure 5-28. PWB-A Removal
Revision A
117