Transfer Switch Solenoid (Sl1) Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units

4.2.11 Transfer Switch Solenoid (SL1) Removal

1. Remove the Rear Cover. (Refer to Section 4.2.2.)
2. Release the harness for the solenoid from four cable clamps around
the Transport Motor and disconnect the harness from the relay
connector.
3. Remove the screw (3501) securing the bracket for the Transfer
Switch Solenoid to the Unit Frame and remove the solenoid.
4. Remove two screws (1305) securing the bracket to the Transfer
Switch Solenoid and remove the bracket from the solenoid.
Figure 4-20. Transfer Switch Solenoid Removal
5-Bin Unit Disassembly and Assembly of the 5-Bin Unit
When installing the solenoid plunger, join the pin of
the transfer switch tip holder with the installation hole
in the holder on the plunger side.
When removing the solenoid, pay attention to the
plunger as it is breakable.
Revision A
86