Adjust Clamp Height; Change Stop Position - Duerkopp Adler 511 Installation Instructions Manual
Cnc automat for bartacking seams and short seams
Hide thumbs
Also See for 511:
- Service instructions manual (44 pages) ,
- Fitting instructions manual (12 pages) ,
- Operating instructions manual (102 pages)
Table of Contents
Advertisement
8.2
Adjust clamp height
8.3
Change stop position
ATTENTION: Danger of breakage !
When converting the automatic bartacker to thicker fabrics, you must
adjust the clamp height.
–
Refer to the service instructions in chapter 6.3 for adjusting the
clamp height.
The stop position is set in the technician mode in the menu "Machine
configuration" via the menu item "Stop position" (refer to the operating
instructions in chapter 8.5.4.1).
2
19
Advertisement
Table of Contents
