Mount The Oil Lines; Mount The Control Panel - Duerkopp Adler 511 Installation Instructions Manual
Cnc automat for bartacking seams and short seams
Hide thumbs
Also See for 511:
- Service instructions manual (44 pages) ,
- Fitting instructions manual (12 pages) ,
- Operating instructions manual (102 pages)
Table of Contents
Advertisement
4.3
Mount the oil lines
4.4
Mount the control panel
12
10
–
Fasten oil lines 8 and 9 in the oil pan with the fitting clip 10.
The oil filter must be completely surrounded by the felt.
4
3
–
Screw on the panel 4 to the automatic bartacker using the angle 3.
Lay rubber washers between the mounting angle of the control
panel and the cast housing.
–
Run the connecting cable 2 under the table top through oil pan 1.
9
8
2
1
Advertisement
Table of Contents
