Duerkopp Adler 511 Installation Instructions Manual page 29

Cnc automat for bartacking seams and short seams

Hide thumbs Also See for 511:

Table of Contents

–

Now remove the dongle.

–

If necessary, confirm the software version by pressing the "OK"

key.

CAUTION !

The machine software must match the machine class.

If the software version differs from the machine class, do not

confirm the loading.

Switch the machine off and repeat the loading process using

the correct software version.

The adjustment of the control unit is described in the operating

instructions in chapter 8 "Operating the 511 Control Unit".

The number of the installed clamping foot must be specified before

switching on the bartacker for the first time.

–

Plug in the power supply plug.

–

Turn on the main switch.

The control unit is initialized.

The following menu appears:

–

Press the "OK" key.

–

Enter the corresponding number of the clamping foot using keys "ñ

" or "ò ".

–

Press the "OK" key.

–

Press the "ESC" key. The screen changes over to the main menu.

Table of Contents