8.2 Adjust clamp height
See service instructions chapter 6.3 for adjusting the clamp height.
8.3 Change thread wiper
8.4 Change stop position
20
ATTENTION Risk of breakage!
When converting the automatic bartacker to thicker fabrics
adjust the clamp height in any case.
ATTENTION Risk of breakage!
When converting the automatic bartacker to thicker fabrics change
without fail the thread wiper.
See service instructions chapter 4.3 for changing the thread wiper.
The stop position is set in the technician mode in the menu "Machine
configuration" via the menu item "Stop position" (see operating
instructions chapter 8.5.4.1).