3.3
Complete the table top
6
6
5
4
3
–
Place the table top on a worktop upside down.
–
Screw the main switch 6 on the underside of the table top on the
left.
–
Screw cable duct 5 tight behind the main switch 6.
–
Screw cable duct 2 tight to the left of the lead-through 1.
–
Put the access line 4 in the cable duct.
–
Fasten the access line 4 by means of strain relief 3.
–
Place the control box 7 on the underside of the table top and
position it in such a way that the side with the four sockets points to
the left (towards the thread reel holder).
–
Screw the control box with four screws on the punch-marked spot
at the underside of the table top.
2
1
7