Oil Lubrication; Topping Up With Oil - Duerkopp Adler 511 Installation Instructions Manual

Cnc automat for bartacking seams and short seams
Table of Contents

Advertisement

9.

Oil lubrication

9.1

Topping up with oil

Caution – Risk of Injury !
Oil can cause skin rashes.
Avoid prolonged skin contact.
If oil or grease contacts your skin, wash yourself thoroughly.
CAUTION !
The handling and disposal of mineral oils is subject to legal
constraints.
Dispose of used oil at an authorized collecting station.
Protect your environment.
Take care not to spill any oil.
Fill up the oil reservoirs exclusively with lubricating oil DA-10 or
equivalent oil with the following specification:
– Viscosity at 40° C:
– Flash point:
DA-10 can be purchase at the
DÜRKOPP-ADLER AG sales branches under the following parts
numbers:
250-ml container:
1-litre container:
2-litre container:
5-litre container:
Oil reservoir for lubricating the automatic bartacker
Fill up oil through drill-hole 1.
This will fill up both reservoirs.
Use the two inspection glasses 2 and 3 to check the oil level.
The oil level must be above the red marking of both inspection
glasses.
2
10 mm
/s
150° C
9047 00001 1
9047 00001 2
9047 00001 3
9047 000014
3
1
2
20

Advertisement

Table of Contents
loading

Table of Contents