Assembly Of The Crank - Duerkopp Adler 511 Service Instructions Manual

2.2

Assembly of the crank

4 1
Caution – Risk of injury !
Turn the main switch off.
Remove and mount the crank only when the automatic bartacker is
switched off.
Rule:
The crank 4 has to be mounted on the arm shaft 1 in such a way that
the pivot 3 of the screw 2 reaches into the drill-hole on the arm shaft.
The screw 2 is the first screw in the direction of rotation.
Assembly
–
Push crank 4 on arm shaft 1.
–
Turn crank 4 so that its first drill-hole in the direction of rotation is
located above the drill-hole in the arm shaft 1. Insert screw 2 with
pivot 3 and screw tight.
–
Insert screw 5 and tighten.
5
4
2
3
3
5