2.9
Reference position of the sewing motor
2.9.1
Position of the initiator
Caution – Risk of injury !
Turn the main switch off.
Check and adjust the initiator only when the automatic bartacker is
switched off.
Rule and control
The distance between the initiator 1 and the 180° disc 2 should be kept
as small as possible.
Correction of the distance between the 180° disc and the initiator
–
Loosen the screw on the initiator's clamping piece.
–
Adjust the initiator lengthwise so that there is a minimal gap to the
180° disc.
–
Turn the machine with the handwheel in order to check that there is
a gap clearance.
–
Re-tighten the screw to the clamping piece.
1
2
3
13