3.3
Gear segment to the driver shaft
3
2
1
Caution – Risk of injury !
Turn the main switch off.
Check and adjust the gear segment only when the automatic
bartacker is switched off.
Rule and control
The gear segment 3 should grip into the toothed wheel 2 of the
driver shaft with the smallest clearance possible, but it must
not move sluggishly.
–
Turn handwheel and check clearance between gear segment 3
and toothed wheel 2.
Adjusting
–
Loosen Allen screws 1.
–
Twist camshaft 4 counter-clockwise until the clearance between
gear segment 3 and toothed wheel 2 is as small as possible.
–
Turn handwheel and check clearance between gear segment 3
and toothed wheel 2.
–
Press the adjusting ring 5 to the right against the casing.
–
Tighten Allen screws 1.
5
4
1
3
2
3
19