Oil Lubrication - Duerkopp Adler 511 Service Instructions Manual

Cnc automat for bartacking seams and short seams
Table of Contents

Advertisement

7.

Oil Lubrication

36
Caution – Risk of injury !
Oil can cause skin rashes.
Avoid prolonged skin contact.
If oil or grease contacts your skin, wash yourself thoroughly.
CAUTION !
The handling and disposal of mineral oils is subject to legal
constraints.
Deliver used oil to an authorized reception point.
Protect your environment.
Take care not to spill any oil.
Oil the automatic bartacker exclusively with the lubricating oil DA-10 or
equivalent oil with the following specification:
Viscosity at 40° C:
Flash point:
DA-10 can be purchased at sales branches of
DÜRKOPP ADLER AG, under the following part number:
250-ml container:
1-Litre-Container:
2-litre container:
5-litre container:
Lubrication of the automatic bartacker
3
The automatic bartacker is equipped with central oil wick lubrication.
The bearings are supplied by the oil reservoirs 2 and 3.
The oil level must not drop below the red marking of both reservoirs.
Fill oil though the drill-hole 1, up to the red mark on the reservoir 3.
The reservoir 3 is filled by the overflow of reservoir 2.
10 mm²/s
150° C
9047 000011
9047 000012
9047 000013
9047 000014
2
1

Advertisement

Table of Contents
loading

Table of Contents