Thread Trimmer; Thread Trimmer Magnet - Duerkopp Adler 511 Service Instructions Manual

5.

Thread Trimmer

5.1

Thread trimmer magnet

4
26
3 2 1
Caution – Risk of injury !
Turn the main switch off.
Check and adjust the thread trimmer magnet only when the
automatic bartacker is switched off.
Rule and control
The magnet 3 pushes the lever 6 with the roller bolt into the
thread trimmer cam 5 by means of lever 1.
When the roller bolt is pushed in, it must have some axial clearance
in the cam.
–
Push magnet shaft 2 into the magnet and check whether
there is some clearance between the roller bolt and the
thread trimmer cam.
Adjusting
–
Loosen screws 4.
–
Press together magnet shaft 2 and magnet 3.
–
Then push the magnet to the left as far as it will go.
–
Shift magnet back minimally.
–
Tighten screws 4.
–
Check whether there is some clearance between the roller bolt and
the thread trimmer cam when the roller bolt is pushed in.
6 5