Bevel Gear For The Hand Wheel - Duerkopp Adler 511 Service Instructions Manual

2.4

Bevel gear for the hand wheel

8
1
Caution – Risk of injury !
Turn the main switch off.
Check and adjust the bevel gear only when the automatic bartacker is
switched off.
Rule and control
The bevel gear 1 has to be positioned on the upper shaft in such a way
that when the handwheel 2 is engaged and there is as little clearance
as possible between bevel gear 1 and bevel gear 3.
–
Engage handwheel 2.
–
Check whether there is as little clearance as possible between
bevel gear 1 and bevel gear 3.
Adjusting
–
Loosen screws at the bevel gear 1.
–
Engage handwheel 2.
–
Press bevel gear 1 against the toothed wheel 3 and tighten
fastening screws.
–
Turn handwheel and check whether there is as little clearance as
possible between bevel gear 1 and toothed wheel 3.
1 3 2