Duerkopp Adler 511 Service Instructions Manual page 37

Cnc automat for bartacking seams and short seams

Hide thumbs Also See for 511:

Table of Contents

–

Screw on gauge 6 (see chapter 6.1) with the two screws 7 and 8.

–

Turn the main switch on.

The machine head goes to the machine zero position.

–

Move needle bar down using the handwheel and check whether the

needle points to the marking 9 on the gauge 6.

Adjustment of the Y axis

–

Loosen screw 11.

–

Adjust switch lug 10 correspondingly.

–

Tighten screw 11.

Adjustment of the X axis

–

Loosen screw 12.

–

Adjust switch lug 13 correspondingly.

–

Tighten screw 12.

–

Turn main switch off and on again.

The automatic bartacker goes to the machine zero position.

–

Move needle bar down using the handwheel and check whether the

needle points to the marking 9 on the gauge 6.

Table of Contents