Bevel Gear For The Handwheel - Duerkopp Adler 510 Operating/Service Instructions Manual

2.4 Bevel gear for the handwheel

8
1
Caution: Danger of injury!
Switch off main switch.
Check and adjust bevel gear only when the automatic bartacker is
switched off.
Standard checking
The bevel gear 1 has to be positioned on the upper shaft in such a way
that - when the handwheel 2 is engaged - there is as little clearance as
possible between bevel gear 1 and bevel gear 3.
–
Engage handwheel 2.
–
Check whether there is as little clearance as possible between
bevel gear 1 and bevel gear 3.
Correction
–
Loosen screws at bevel gear 1.
–
Engage handwheel 2.
–
Press bevel gear 1 against the toothed wheel 3 and tighten
fastening screws.
–
Turn handwheel and check whether there is as little clearance as
possible between bevel gear 1 and toothed wheel 3.
1 3 2