Operation Power; Operation Speed Control; Operation Reversing Airflow; Operation Lights - Casablanca Brescia Instructions Manual

The button is normally left in the on position. Always turn the power off during
cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter ad-
ditional programs.
The button must be left on to retain a previously set fan speed or light level.
There are six individual speed settings for the fan; each speed is indicated by an
audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled
at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the same
speed each time the
the fan on by pressing
off, then on by pressing and holding the
is reached. When the fan is on, you may increase the speed by pressing and
holding the button until the desired speed is reached, then release it.
The direction of airflow can be changed from downward to
upward or from upward to downward.
To reverse the airflow:
1. Make sure the
ing.
2. Press the button.
To turn the lights off and on, press and release the
1) First press/release of the
2) Second press/release of the
To vary the light brightness at each touch level:
to vary the light brightness:
1. With lights off, press and hold the button. After one second the lights will
come on at their lowest level and gradually become brighter.
2. Release the button when the desired brightness level is reached.
notE: Light Operation - the light varies from "bright" to "dim" over
approximately 8 seconds. This sequence will reverse the light when it reaches
the brightest or dimmest level if you continue to hold the LIGHT button.
Release the button when the desired level is reached.
The brightness level is now in the fan memory and will automatically come on at
the same brightness the next time the button is used.
14
3
®

OPERATION POWER

OPERATION SPEED CONTROL

. The fan blades will start rotating
button is used. To maintain this level of speed, turn
less than one second. To lower speed, turn fan
button until the desired speed

OPERATION REVERSING AIRFLOW

is on and blades are Turn-

OPERATION LIGHTS

button- The light will turn ON.
button- The light will turn OFF.
FAN CONTROL
A momentary
press of the FAN
CHANGE SPEED:
Press and hold
FAN button longer
than one second
note: A four-toned signal
indicates the command was
accepted by the fan. A few
seconds later the fan will slow
to a stop and then reverse
direction.
button for less than one second.
ON - OFF:
button
LIGHT CONTROL
ON - OFF:
A momentary press of
the light button
CHANGE BRIGHT-
NESS:
PRESS AND HOLD
LIGHT BUTTON
LONGER THAN ONE
SECOND