Table of Contents
Advertisement
CEILING MEDALLION PREPARATION AND INSTALLATION
CEILING MEDALLION HARDWARE (not to scale)
Ceiling Medallion Bracket
Screw Pack A:
Adjuster Screws (4)
Step 1a: Lay ceiling medallion bracket on flat surface, flat
side down. Insert four adjuster screws (Pack A) in outer
screwholes as shown and hand-twist two full full turns.
Step 1b. Insert motor housing screws (Pack B) into three
screwholes as shown in picture and hand-twist two full turns.
Step 1c. Turn ceiling medallion bracket over and raise flat
side to ceiling.
CEILING MEDALLION BRACKET INSTALLATION
Step 2a. Remove the knockout plug in the center of the out-
let box.
Step 2b. Route the outlet box wires through the center hole
of the ceiling medallion bracket. Attach the ceiling medal-
lion bracket to the outlet box with the screws provided (Pack
C), ensuring that the outlet box wires are not pinched by the
washer.
CAUTION:
To reduce the risk of personal injury, use only the
mounting hardware provided with the approved
outlet box to install the ceiling medallion bracket.
WARNING!
Support directly to building structure only.
4
Motor Assembly
Screw Pack B:
Motor Housing Screws (3)
Motor Housing
B
A
B
A
Medallion Plate
Screw Pack C:
3" x 10-32"
roundhead screws (2)
1
/
" x 8-32"
1
2
roundhead screws (2),
washers (4),
nuts (4)
A
B
A
Advertisement
Table of Contents
