Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Brescia Instructions Manual

Step 5. To hang the fan body in the
canopy, hold the fan body firmly and insert
the ball into the canopy opening. Check
that no wires were pinched. Rotate the fan
body until the slot in the ball fits into the
pin opposite the canopy opening.
Fan Hanging Weight
is 27 lbs
Step 6a. Attach the fan wires to the ceiling fixture outlet box
wiring by twisting the bare ends of the wires together and then
securing with a wire nut. Test that the connection is secure by
pulling on the wire nut. Connect in this order:
Step 6b. W-85 Wiring Connections
• GREEN leads from mounting plate and fan to GROUND conductor
of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet
box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in ceiling outlet
box. Secure with wire nut.
Step 6c. Pull Chain Connections
• GREEN leads from mounting plate and fan to GROUND conductor
of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet
box. Secure with wire nut.
• BLACK power wire from fan to Black wire from W-81 in ceiling outlet
box and the BLUE wire form light kit. Secure with wire nut.
• BLUE wire from fan to YELLOW wire from W-81 in ceiling outlet
box. Secure with wire nut.
If you will be installing an accessory light kit, also connect
the BLUE light power wire from fan to the BLACK wires).
Note: If you are using this fan with an accessory control (W-
41, W-81, or W-52), see page 21.
Step 7. Tuck the wires into the canopy with
the wire nuts pointed upwards, so that the
WHITE and BLACK wires are on opposite
sides of the canopy and all wires are clear
of the canopy opening.
Step 8. Install canopy hatch with the last
canopy screw and lock washer. To do
this, tilt the fan body away from the hatch
opening.
Using the screwdriver, tighten the screws
firmly by hand only.
Step 9. Straighten the fan, then check to
ensure that there is no movement between
the canopy and ceiling or Hang-Tru ball
and top support shaft.
6

hAngIng ThE fAn

CANOPY ELECTRICAL CONNECTIONS

CAnopy hATCh InSTAllATIon

Note: Write down the
Serial Number and
the model number for
future reference.
BAll
SloT
WIRE NUT
2 BLACK
2 WHITE WIRES
3 GREEN
WIRES
2 BLACK + 1
BLUE
2 WHITE WIRES
3 GREEN WIRES
CAnopy
hATCh
loCK
wAShER
CAnopy
SCREw
pIn
W-85 CONNECTIONS
PULL CHAIN
CONNECTIONS
TIlT ThE fAn
To InSTAll
lAST CAno-
py SCREw