1. Manuals
  2. Brands
  3. Casablanca Manuals
  4. Fan
  5. Bel Air Bel Air Tabletop Fan
  6. Owner's manual

Casablanca Bel Air Bel Air Tabletop Fan Owner's Manual

Casablanca bel air owner's manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
B
A
™
EL
IR
OWNER'S MANUAL

Advertisement

Table of Contents
loading

Related Manuals for Casablanca Bel Air Bel Air Tabletop Fan

Summary of Contents for Casablanca Bel Air Bel Air Tabletop Fan

  • Page 1 ™ OWNER’S MANUAL...

  • Page 3: Safety First

    • This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling installations.

  • Page 4: Mounting Recommendations

    MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mount- ing recommendations as you decide where to install your Casablanca fan.

  • Page 5: Installation Instructions

    Before discarding packaging material, be certain that all parts have been removed. IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging from the box. After removing the top cover from the upper half of the styrofoam, take the packaging from the box and put it on the floor.

  • Page 6: Crossbar Mounting Bracket Installation

    8-32 x 2 canopy screws and canopy lock washers. Tighten the screw firmly by hand only. Note: On sloped ceilings, align the canopy opening towards the top or room peak. ™ CEILING FAN APPROVED OUTLET BOX CEILING WIRING CROSSBAR MOUNTING...
  • Page 7 Place the fan in the recessed circle that the top cover was in. Step 3. Locate the three tabs on the top of the fan motor assembly.

  • Page 8: Hanging The Fan

    CANOPY ELECTRICAL CONNECTIONS and fan to GROUND conductor of power source. Secure with wire nut. TRAL wire in ceiling fixture outlet box. Secure with wire nut. POWER wire in ceiling fixture outlet box. Secure with wire nut. HANGING THE FAN...
  • Page 9 ‘wiggled’ a little from side to side. It is a great help when rotating the glass shade to ‘wiggle’ it at the same time. PROCEED TO YOUR FAN’S CONTROL FEATURE SECTION FOR INSTALLATION/OPERATING INSTRUCTIONS: INTELI•TOUCH = PAGE 10 FLAT WASHER...
  • Page 10 The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 1.

  • Page 11: Inteli•Touch Operation

    It is also used to exit or enter additional programs. POWER must be left on to retain a previously set fan speed or light level. INTELI•TOUCH OPERATION There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.

  • Page 12: Light-Minder ® Program

    3. Immediately operate the buttons in the following sequence: 4. The fan controller will respond with three descending tones. A timer is now initiated and the fan will reduce one speed for each two-hour interval. The fan will not, however, descend below the second lowest speed.

  • Page 13: Troubleshooting

    WHEN AC POWER IS TURNED ON FOR THE FIRST TIME, THE LIGHTS OPERATE NORMALLY, BUT W-32 WALL CONTROL OPERATION IS REVERSED: FAN BUTTON OPERATES THE LIGHTS; LIGHT BUTTON OPERATES THE FAN: Reverse the 2 black and white striped wire connections.

  • Page 14: Mounting Parts

    WARNING: Use of batteries other than non-leak sealed alkaline in the remote control will void the warranty and can destroy the unit. Note: When the remote is in the low battery mode the fan may not respond to control commands correctly even though the fan may be running.

  • Page 15: Fan Operation

    COMFORT•TOUCH The Comfort•Touch fan is controlled by the remote control. The fan is turned on and off by alternate pushes of the large right hand button. As with all button operations, an audio tone sounds with each push. With the fan on, the control display will indicate an up or down moving arrow that shows direction and places a box around the operating speed.
  • Page 16 The words 'AUTO SPEED' show on the display. Set AUTO the fan speed to the speed at which you are most comfortable. Once set, the fan will increase or decrease by one speed for each 1.5 F increase or decrease in temperature.
  • Page 17 When two controls are used for the same fan, we suggest that both controls be set for the same features (AUTO-SPEED, SAVER, etc.) so that performance remains the same as you move from one to the other.
  • Page 18 FAN DOES NOT RESPOND TO REMOTE CONTROL: Power to fan is off; wrong remote being used; remote channel changed; fan receive SET channel changed; or fan antenna not receiving. See above; in locations with two or more fans in different rooms check that controllers are in right rooms;...
  • Page 19 761 C • P , CA 91768 ORPORATE ENTER RIVE OMONA : 888-227-2178 www.CasablancaFanCo.com ©C 1999 C • U.S. P OPYRIGHT ASABLANCA OMPANY ATENT ENDING...

This manual is also suitable for:

Bel air

Table of Contents