Brother CB200 Service Manual page 78

Thank you very much for your patronage. We have repaired your printer and are sending it back
to you.
To ensure you get the most out of the performance in the machine, follow all instructions given
below.
(1) Clean the whole surface of the looped copyboard screen while scrolling it slowly by hand. If
stains cannot be wiped off easily, use a soft cloth dampened with water.
(2) Connect the printer to the copyboard and set up the machine according to the setting-up
instructions given in the User's Manual. Make sure that the printer-copyboard interface cable
and the AC adapter cable are plugged in firmly.
(3) Load the recording paper to the printer. Check that it is not slack.
(4) Turn the power on.
The machine automatically scrolls the copyboard screen for home positioning and starts
setting the scanning compensation parameters stored in the EEPROM.
operation may take approx. three minutes during which the PAPER LED flashes.
(5) Upon completion of the automatic setting, the machine turns off the PAPER LED and returns
to the regular operation mode.
(6) If the machine fails to set those parameters, it will print out an error sheet.
If ERR=A4, go to step (7).
If ERR=AB, skip to step (8).
If ERR=B3, go back to step (2).
(7) Turn the power off and check the copyboard screen for stains. Then repeat steps (2) through
(4).
If the error still persists, power off the machine and clean the scanner (CIS units) according to
the User's Manual, "Maintenance, Cleaning the scanner." And then repeat steps (1) through
(4) again.
If the error still persists, the scanner components may be defective. With the error sheet
close at hand, call the telephone number given below.
(8) Turn the power off. Turn the power on and check that the copyboard screen scrolls normally.
If any abnormal noise is heard or the scrolling speed is abnormally low, the screen drive
components may be defective. With the error sheet close at hand, call the telephone number
given below.
If the copyboard screen scrolls normally, go back to step (7).
TEL NO.: XXX-XXX-XXXX (telephone number of the service station)
Read This First
User Setup Guide for Repaired Machine
V - 4
Sample
This automatic