Removing The Wb Motor Harness, Relay Pcb, And Printer-Copyboard Interface Cable - Brother CB200 Service Manual

Removing the WB motor harness, relay PCB, and printer-copyboard interface cable

(5) Disconnect the WB motor harness from the relay PCB and the WB motor. On the relay PCB,
straighten the cable clip and pull out the ferrite core of the harness. Then take the WB motor
harness out of the cable clamps.
(6) Remove the tape from the CIS harness set and straighten the two cable clips.
(7) Disconnect the red CIS harness from the relay PCB and pull it out from the cable clip. In the
same way, release the yellow and blue CIS harnesses.
III - 27