Removing The Head Protector, Recording Head Assy, Recorder Frame, And Pe/Cover Sensor Pcb - Brother CB200 Service Manual

Removing the head protector, recording head ASSY, recorder frame, and PE/cover sensor
PCB
(17) While pulling up the left end of the head protector, unhook latches
with a small flat screwdriver as illustrated below.
(18) Push down both ends of the recording head ASSY and move it to the rear to release the tabs
from the cutouts provided in the recorder frame.
(19) Disconnect the two harnesses (recording head signal and power harnesses) from the
recording head ASSY and then lift it up.
(20) Remove three head springs.
III - 19
• „
through in this order