Using The Scsiselect Utility Program (Some Models); Starting The Scsiselect Utility Program; Choices Available From The Scsiselect Menu - IBM NetVista X40 User Manual

If you forget the power-on password, you can regain access to the computer
through either of the following methods:
v Start the Configuration/Setup Utility program and change the power-on
v Change the jumper position on the complimentary metal oxide semiconductor

Using the SCSISelect Utility program (some models)

SCSISelect is a built-in, menu-driven configuration utility program that you can
use to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
The following sections provide the instructions for starting the SCSISelect Utility
program and descriptions of the menu choices that are available.

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect Utility program:
1. Turn on the computer.
2. When the
3. When the
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected

Choices available from the SCSISelect menu

The following choices appear on the SCSISelect Utility menu:
v Configure/View Host Adapter Settings
® ®
30
IBM IntelliStation E Pro: User's Guide IntelliStation E Pro Types 6836, 6846
password.
(CMOS) jumper as described in "Clearing CMOS" on page 103.
appears, press Ctrl+A.
question appears, make your selection and press Enter.
v Press Esc to exit the SCSISelect Utility program.
v Press the F5 key to switch between color and monochrome modes (if your
monitor permits).
items; then, press Enter.
Select this choice to view or change the SCSI controller settings. To reset the
SCSI controller to its default values, press F6; then, follow the on-screen
instructions.
You can view or change the following controller settings:
– Host Adapter SCSI ID
Select this choice to view the SCSI controller identification (ID), which is
usually 7.
– SCSI Parity Checking
Select this choice to view the assigned value of Enabled.
– Host Adapter SCSI Termination
Select this choice to view the assigned value of Automatic.
– Boot Device Options
Select this choice to configure startable-device parameters. Before you can
make updates, you must know the ID of the device whose parameters you
want to configure.
– SCSI Device Configuration
prompt