IBM NetVista X40 User Manual page 116

10. When prompted as to whether you want to save the current code to a
11. When prompted enter Y to continue the flash process. The system
12. When prompted as to whether you want to save the current BIOS, stop the
13. Remove any media (diskettes, CDs, or tapes) from the drives; then, shut down
14. Turn off the computer and all attached devices and disconnect all external
15. Remove the cover. See "Removing the side cover" on page 45 for the tower
16. Move the JROM1 jumperto the normal position (pins 2 and 3) to return to
17. Reinstall the computer cover. See "Installing the cover" on page 58 for the
18. Reconnect the external cables and power cords; then, turn on the attached
® ®
100
IBM IntelliStation E Pro: User's Guide IntelliStation E Pro Types 6836, 6846
4. Locate jumper JROM1 on the system board.
Note: The PCI extender board is only available in the tower model.
5. Move the JROM1 jumper to the alternate position (pins 1 and 2) to enable
BIOS recovery mode.
6. Reinstall the computer cover, see "Installing the cover" on page 58 for the
tower model and "Installing the cover" on page 69 for the desktop model.
7. Reconnect all external cables and power cords and turn on the attached
devices.
8. Insert the BIOS flash diskette in the diskette drive.
9. Restart the computer. The BIOS begins the power-on self-test; then, the BIOS
Flash Utility starts.
diskette, select N.
automatically starts the Flash Utility a second time.
process by removing the BIOS flash diskette from the diskette drive.
your operating system.
cables and power cords.
model and "Removing the computer cover" on page 59 for the desktop model.
normal startup mode.
tower model and "Installing the cover" on page 58 for the desktop model.
devices and the computer. They should start up normally.
1
2
3
CMOS jumper
(JBAT1)
3
2
1
Boot block jumper
(JROM1)