Ethernet Teaming Messages - IBM NetVista X40 User Manual

Table 7. NDIS (Windows NT) driver messages for the Ethernet controller (continued)
Error code (hex) Description
0x0E Explanation: Could not allocate enough memory for receive queue. Action:
1. From the Windows NT desktop, select Start --> Control Panel --> Networks --> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties --> Advanced.
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures. Action:
1. From the Windows NT desktop, select Start --> Control Panel --> Networks --> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties --> Advanced.
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers. Action:Using the Configuration/Setup
Utility program, make sure that Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID.
Action:Using the Configuration/Setup Utility program, make sure that Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.
Action:Using the Configuration/Setup Utility program, make sure that Ethernet is enabled.
0x16 Explanation: Single adapter found, but multiple instances tried to load. Action:Using the
Configuration/Setup Utility program, make sure that Ethernet is enabled, and that the slot
containing the IBM IntelliStation 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI
adapter is enabled.
0x17 Explanation: Slot parameter not specified in the registry. Action:Remove the adapter driver and
reinstall it. If the problem persists, call for service.
All other Action:Call for service.
4-character
hexadecimal
codes

Ethernet teaming messages

This section displays the messages associated with Ethernet teaming.
Table 8. NDIS (Windows NT ) driver teaming messages for the Ethernet controller
Event ID Type
01 Error
02 Error
03 Error
04 Error
05 Error
06 Informational
07 Informational
08 Informational
Description
Explanation:Team Name and physical adapter name are the same. This is
an invalid configuration. Action:Reconfigure the adapter team by
double-clicking the PROSeticon in the control panel.
Explanation:Unable to allocate required resources. Action:Free some
memory resources and restart.
Explanation:Unable to read required registry parameters.
Action:Reconfigure the adapter team by double-clicking the PROSeticon
in the control panel.
Explanation:Unable to bind to physical adapter. Action:Reconfigure the
adapter team by double-clicking the PROSet icon in the control panel.
Explanation:Unable to initialize an adapter team. Action:Reconfigure the
adapter team by double-clicking the PROSet icon in the control panel.
Explanation:Team nn. Primary adapter is initialized. Action:None.
Explanation:Team nn. Secondary adapter is initialized. Action:None.
Explanation:Team nn. Virtual adapter or Team is initialized. Action:None.
Chapter 6. Solving problems
97