Table of Contents
Advertisement
STATUS AREA
The Status area (Figure 6-1) displays what mode
the HDX-SDI is in. It also provides helpful status
information and troubleshooting suggestions. For
example, if there is no video signal because of a
wrong setting, the Status area will tell you which
setting(s) to check.
INPUT STATUS
The Input Status (Figure 6-1) indicates the video
format detected on the currently chosen video
Input Source.
GENLOCK STATUS
The Genlock Status (Figure 6-1) indicates when the
HDX-SDI has successfully achieved lockup to the
currently selected clock source, which could be the
HDX-SDI's internal clock, the video REF IN jack
or the current video input source.
Figure 6-4: Setup tab.
M O T U V I D E O C O N S O L E
SETUP TAB
The Setup tab (Figure 6-4) provides several general
settings for HDX-SDI operation.
Default Mode
The HDX-SDI has two modes of operation:
Capture and Playback. Your host video software
determines the mode, depending on what you are
doing (i.e. capturing or playing back the timeline).
The Default Mode setting (Figure 6-1) lets you
choose which mode the HDX-SDI enters when the
host relinquishes control over the HDX-SDI
hardware, such as when you quit or switch out of
your host software. If you spend most of your time
just monitoring or just capturing, operation will be
faster if you set this to the mode you expect to use
most.
37
Advertisement
Chapters
Table of Contents
