A Typical 828Mkii Setup (No Mixer) - MOTU 828mkII User Manual

A TYPICAL 828MKII SETUP (NO MIXER)

Here is a typical 828mkII studio setup. This rig can
be operated without an external mixer. All mixing
and processing can be done in the computer with
audio software. During recording, you can use the
828mkII's CueMix™ DSP no-latency monitoring
to listen to what you are recording via the main
guitar
(with or without a
modeling amp)
Mac
828mkII
back panel
ADAT optical
ADAT
20
828mkII
front panel
FireWire
S/PDIF
DAT deck
Figure 3-5: A typical 828mkII studio setup.
outs, headphone outs, or any other output pair. You
can control monitoring either from the front panel
or from the included CueMix Console software.
The two front-panel guitar/mic inputs can be
routed to outboard effects processor, such as a
compressor, EQ or reverb, via the rear panel sends.
mic headphones
foot
sends to other outputs (stage
switch
FX unit monitors, surround
(in rack monitors, etc.)
below)
quarter-inch
MIDI IN/OUT analog outs
synthesizer
I N S T A L L I N G T H E 8 2 8 M K I I H A R D W A R E
Compressor, reverb or
other outboard gear
monitors
quarter-inch analog outs
synths, samplers, effects units, etc.