Table of Contents
Advertisement
OUTGOING CALLS AND MESSAGES
The device can be used for
•making information calls and/or
•sending position reports and
•making emergency calls and/or
•sending emergency messages.
In addition, the device may automatically send some MPTP
messages to the service center or some other authorized
number. Such messages can be, e.g.
•Power notifications
•Lost satellite coverage notifications
•Position updates (e.g. when the device is being tracked in
emergency mode)
•Some other types of calculated positions sent in sequence
(e.g. by using
Waypoint tracking
•Individual position information sent as a response to an
MPTP request (e.g. Tracking, Area tracking, Location
request, History request). For more information, see
TIONING FEATURES ON PAGE 42
For more information on MPTP messages, please see the
separate document on MPTP commands, located at the Web
site: www.benefon.com.
38 OUTGOING CALLS AND MESSAGES
PART C: OPERATING THE SERAPH
)
POSI-
.
Making information calls
To make an information call, press
a few seconds.
The call number needs to be configured in the device in ad-
vance. Depending on configuration, the device may simulta-
neously send position report, as well. For more information,
see
.
CALLING ON PAGE 16
Sending position reports
To send a position update, press
few seconds.
The position report number must be configured in the de-
vice in advance. Depending on configuration, the device
may simultaneously make information call, as well. For
more information, see
CALLING ON PAGE 16
NOTE: The recipient of the position report might call you
back. In this case, you can answer the incoming call by press-
l
ing
. Depending on configuration, the device may also an-
swer the incoming call automatically. In order to receive the
incoming call, the caller must be an allowed caller. For more
information on both settings, see
.
17
l
and hold it down for
l
and hold it down for a
.
ALLOWED CALLERS ON PAGE
Advertisement
Table of Contents
