Table of Contents
Advertisement
PART C: OPERATING THE
SERAPH
USER INTERFACE
B
ENEGUARD BUTTON
For making emergency
L
calls/sending emergen-
OUDSPEAKER
cy messages
S
IDE KEYS
•Upmost:
Power on/off
•Middle: For
increasing volume
•Lowmost: For
decreasing
volume and silen-
cing ringing tone
E
ND KEY
•For rejecting/
ending calls
•For cancelling
some operations
S
END KEY
•For making
information call/
sending position
•For answering calls
M
ICROPHONE
PART C: OPERATING THE SERAPH
D
ISPLAY
•GSM status
•GPS status
•Battery status
GPS
ANTENNA
Plug for external
GPS antenna
Battery release
catch
B
ATTERY
S
YSTEM
CONNECTOR
For connecting
charger or data
cable to the
device.
Turning the device on
1. To power on the device, press the upmost side key
hold it down for a few seconds.
2. The logo will be shown.
3. An automatic PIN code entry will take place. If the PIN
code is requested, the PIN code must be programmed in
the device in advance. For more information, see
MATIC PIN ENTRY ON PAGE 30
4. The device will remove all short messages found on SIM
card and go to stand-by mode. The device may also no-
tify the service center of the power on. For more infor-
mation, see
SETTINGS FOR MANUAL POWER ON AND OFF ON
.
PAGE 27
NOTE: If the PIN code is incorrect or the SIM card is
not inserted at all, the normal network connection is
unavailable and the device can only be used for ma-
king network emergency calls (e.g. 911, 112).
There are two other ways to power on the device:
•By pressing the BeneGuard button
down for a few seconds. NOTE: This action will start the
emergency cycle (unless cancelled in time).
•By connecting the device to a charger.
/
and
AUTO-
.
<
and holding it
USER INTERFACE 31
Advertisement
Table of Contents
