Table of Contents
Advertisement
PART B: CONFIGURING SETTINGS FOR THE SERAPH
WAYPOINT TRACKING
5
4
1
Waypoint tracking is remotely controlled by the service cen-
ter. When the waypoint tracking is turned on, the alarm
(incl. position information) will be sent to the service center
when the device is moving out or in to the pre-defined area.
The device can also be configured to send the position in-
formation to the service center whenever crossing the bor-
derline - despite of the moving direction.
NOTE: When entering into the pre-defined area, the alarm
will be sent when crossing radius. When entering out of the
pre-defined area, the alarm will be sent when crossing radi-
us plus perimeter of 100 meters.
•
Name
(1): You may key in the desired name for a waypoint
. You can define up to 30 separate, circular areas: The
areas are separated from each other by an ID number and
a name.
•
Center point coordinates
(2): The waypoint area is defined
by keying in
Latitude
and
2
3
Longitude
and a
Radius
of an
area in meters. The radius should be rounded to tens,
otherwise the software does the rounding. E.g. by enter-
ing 67, the actual radius will be rounded to 70 meters. 50
meters is the minimum value.
•
Alarm
(3): After activating a waypoint, you can select an
alarm option for this waypoint. You have three choices:
Alarm will be turned on when arriving to a waypoint,
departing from a waypoint, or whenever crossing the bor-
derline (both directions). Each waypoint can have alarm
option of its own.
•
Activation of a waypoint
(4): To activate a waypoint, check
the
Active
box (on the same row), to deactivate the way-
point, leave the check box blank.
NOTE: The waypoint tracking does not contain automatic
switch off or duration options. The feature must be sepa-
rately deactivated when it is no longer needed.
RESETTING THE COORDINATES
To reset the coordinate values, click the latitude and longi-
tude data fields (the ones, you want to reset).
MARKING ALL WAYPOINTS FOR ACTIVATION/
DEACTIVATION AT ONCE
Click the
Active
box on the top row (5).
Note that activation/deactivation will actually take place
only after you have transferred the information to the de-
vice.
WAYPOINT TRACKING 29
Advertisement
Table of Contents
