Table of Contents
Advertisement
PART B: CONFIGURING SETTINGS FOR THE SERAPH
SERAPH SETTINGS: POWER
1
2
3
Settings for manual power on and off
•
No restrictions
(1) - The device can be turned on and off as
usual. The service center will NOT be notified of the
power on/off.
•
Notify service center
(2) - The service center will always be
notified when the device is powered on or off. Notifying
means sending a protocol message to the service center.
4
5
•
No power-off
(3) - The device cannot be powered off nor-
/
mally (by pressing
). Moreover, if the device powers off
for some reason (e.g. Low battery), the device will send a
protocol message to the service center.
Settings during battery loading
CHANGE GPS OPERATING MODE
You can select, which one of the GPS power modes is on
while the device is being charged.
By selecting
No change
, the GPS mode remains in the previ-
ously configured operating mode (i.e. its normal operating
mode).
Set the GPS
Off
in case
•the time reserved for charging is quite short
•GPS functions are not needed during charging process.
Click the arrow and highlight the desired option (4).
NOTIFY SERVICE CENTER WHEN CHARGING
By checking the box (5), the device will notify the service
center in case the device is connected to a charger or discon-
nected from it.
Notifying means sending a protocol message to the service
center, including the latest position.
SERAPH SETTINGS: POWER 27
Advertisement
Table of Contents
