Part D: Power Management; Power Supply; Mains Charger; Charging - Benefon SERAPH NT Operating Instructions Manual

Hide thumbs Also See for SERAPH NT:

Table of Contents

PART D: POWER MANAGEMENT

•Mains charger CMA-70-230 (with the cable FMC-70)

•Cigarrette lighter charger CCS-71-12

•Standard Li-Ion batteries

- 650 mAh (BBL77S)

- 900 mAh (BBL77N)

- 1200 mAh (BBL77P)

- 1700 mAh (BBL77G).

The battery type may vary depending on the market area and

sales package. In unclear cases, check the battery compati-

bility with the dealer.

44 POWER SUPPLY

PART D: POWER MANAGEMENT

The mains charger should only be used indoors. Make sure

that the voltage in the country which you are staying corre-

sponds to the voltage (230 V) of the charger.

When charging, connect the charger (round) end of the ca-

ble into the charger and lock it by turning it half a turn

clockwise. Plug the square end of the cable (with the arrow

facing up) into the system connector on the device.

Plug the charger into a mains outlet. Charging will start au-

tomatically.

The mains charger is provided with the device, but is also

available from the assortment of Benefon accessories. For

more information on other charger types, see

SORIES ON PAGE 46

The battery must be fully charged before taken into use. The

battery will reach its full capacity only after two or three

charging times.

The device controls the charging status, the battery temper-

ature and power supply during the charging operation.

PART E: ACCES-

Table of Contents