Configuring Settings For The Benefon Track Pro; A: Mptp Messages And Remote Configuration (Ota) - Benefon Track Pro Configuration Manual

CONFIGURING SETTINGS FOR THE BENEFON TRACK PRO

CONFIGURING SETTINGS FOR THE
BENEFON TRACK PRO
There are several ways to configure settings for the
Benefon Track Pro:
• A: You can use the MPTP commands, and transfer
settings remotely, over the air by sending a proto-
col message to the phone. The MPTP commands can
be sent as a command string or through a specific
software, such as the Benefon In Charge.
• B: You can use AT commands for configuring set-
tings and transfer them to the phone locally, via the
BW data/NMEA cable. This can be easily done by
using the Benefon Configurator software. In some
cases the BW cable must be purchased separately,
it might not be included in the sales package of the
phone.
• C: Limited set of features or purchased software
options may be available for configuration through
the phone´s own menu.
A: MPTP MESSAGES AND
REMOTE CONFIGURATION (OTA)
MPTP configuration commands are used when a re-
mote update of the phone configuration is needed.
Update can include all telematics settings and phone
numbers, such as emergency numbers, status mes-
sages, authorized numbers, GPS operating mode.
MPTP updates also include commands for daily usage,
such as location request and tracking commands.
The remote configuration can be used for transferring
the settings only in case the settings are coded as
MPTP messages.
For more information on MPTP messages, please
see the separate document: Mobile Phone
Telematics Protocol (MPTP), located at the
Web site: www.benefon.com.
To receive full documentation, please contact
your Benefon Partner.

A: MPTP MESSAGES AND REMOTE CONFIGURATION (OTA) 7