SNMP Management
To set up an SNMP management interface:
1.
Select Maintenance > Remote Management > SNMP. The SNMP screen displays:
Figure 29.
2.
Specify the settings as explained in the following table:
Table 15. SNMP Settings
Field
SNMP
Read-Only Community Name Enter the community string to allow the SNMP manager to read the
Read-Write Community Name Enter the community string to allow the SNMP manager to read and write
Trap Community Name
IP Address to Receive Traps
Trap Port
3.
Click Apply to save your settings.
56 |
Chapter 4. Management
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Description
Select the Enable radio button to allow the SNMP network management
software, such as HP OpenView, to manage the wireless access point
through SNMPv1/v2 protocol. By default, the Disable radio button is
selected.
wireless access point's Management Information Base (MIB) objects. The
default is public.
the wireless access point's MIB objects. The default is private.
The community string to allow the SNMP manager to send traps. The
default is trap.
The IP address of the SNMP manager to receive traps sent from the
wireless access point.
The port number of the SNMP manager to receive traps sent from the
wireless access point. The default is 162.