NETGEAR ProSafe WNAP320 Reference Manual page 67

ProSafe Wireless-N Access Point WNAP320 Reference Manual
The following table explains the fields of the System screen:
Table 17. System Screen Fields
Field
Access Point Information
Access Point Name
Ethernet MAC Address
Wireless MAC Address
Country/Region
Firmware Version
Current Time
Current IP Settings
For information about how to change any of these IP settings, see
Server Settings on page
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings for 802.11n/g
Access Point Mode
Channel / Frequency
Rogue AP Detection
Description
The NetBIOS name. For information about how to change the default name, see
Configure Basic General System Settings and Time Settings on page
The MAC address of the wireless access point's Ethernet port.
The MAC address of the wireless access point's wireless card.
The country or region for which the wireless access point is licensed for use. For
information about how to change the country or region, see
General System Settings and Time Settings on page
Note: It might not be legal to operate this wireless access point in a country or
region other than one of those identified in this field.
The version of the firmware that is currently installed.
The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings on page
21.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCP server
on your LAN network. Disabled indicates a static IP configuration.
The operating mode of the wireless access point. One of the following modes is
indicated:
• Access Point
• Point-to-Point Bridge
• Point-to-Point Bridge with Access Point
• Multi-Point Bridge with/without client association
For information about how to change the mode, see
on page 84.
The channel the wireless port is using. 11 is the default channel when the setting
is Auto. For information about how to change the channel and frequency, see
Configure Basic Wireless Settings on page
Enabled indicates that rogue AP detection is enabled; Disabled indicates that it is
not.
Configure Basic
19.
Configure IP Settings and Optional DHCP
Configure Wireless Bridging
23.
Chapter 4. Management
19.
19.
| 67