ProSafe Wireless-N Access Point WNAP320 Reference Manual
Top Panel
The ProSafe Wireless-N Access Point WNAP320 LEDs are described in the following figure
and table:
Figure 1.
Table 1. Top Panel LEDs
Item
LED
Description
1
Power/Test Off
2
Active
3
LAN
4
WLAN
2
1
On (green)
Amber, then blinking
green
Off
On or blinking (green) Ethernet traffic is detected.
Off
Amber
Green
Off
On or blinking (green) Wireless LAN is ready or wireless activity is detected.
4
3
Power is off.
Power is on.
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
No Ethernet traffic is detected or no link is detected.
10 Mbps or no link is detected.
10/100 Mbps link is detected.
1000 Mbps link is detected.
Wireless LAN is not ready or no wireless activity is
detected.
Chapter 1. Introduction
| 11