NETGEAR ProSafe WNAP320 Reference Manual page 20

2. Specify the fields as explained in the following table:
Table 2. Basic General System Settings
Field
Access Point Name
Country/Region
3. Click Apply to save your settings.
To configure time settings:
1. Select Configuration > System > Basic > Time. The Time screen displays:
Figure 9.
2. Specify the fields as explained in the following table:
Table 3. Time System Settings
Field
Time Zone
Current Time
NTP Client
20 | Chapter 2. Installation and Basic Configuration
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Description
This unique name is the wireless access point NetBIOS name. The name is printed
on the rear label of the wireless access point. The default is netgearxxxxxx, where
xxxxxxx represents the last 6 digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
From the Country/Region drop-down list, select the country where the wireless
access point is installed.
Note: It might not be legal to operate this wireless access point in a region other than
one of those identified in this field.
Description
Select the time zone to match your location.
This is a nonconfigurable field that displays the current date and time.
Enable the Network Time Protocol (NTP) client to synchronize the time of the
wireless access point with an NTP server. By default the Enable radio button is
selected.