Rear Panel
Figure 2.
The rear panel functions of the ProSafe Wireless-N Access Point WNAP320 are described in
the following list:
1.
Reverse SMA connector for an optional 2.4-GHz antenna.
2.
Factory default Reset button. Using a sharp object, press and hold this button for about
5 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
the Wireless Access Point to the Factory Default Settings
3.
Console port for connecting to an optional console terminal. The port has a DB9 male
connector and supports the following settings: 9600 K default baud rate, (8) data bits, no (N)
parity bit, and one (1) stop bit.
4.
10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
5.
Cable security lock receptacle for an optional lock.
6.
Power socket for a 12 VDC, 1A power adapter.
7.
Reverse SMA connector for an optional 2.4-GHz antenna.
12 |
Chapter 1. Introduction
ProSafe Wireless-N Access Point WNAP320 Reference Manual
1
2
3
5
6
7
4
on page 62.
Restore