Using Snmp Remote Management - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Using SNMP Remote Management

Enable SNMP to allow SNMP network management software such as HP OpenView to manage
the wireless access point via the SNMPv1/v2 protocol.
From the main menu of the browser interface, under the Management heading, click the Remote
Management link to view this menu.
Figure 4-6: Remote Management settings
Click Enable to use the SNMP remote management feature.
1.
Fill in the fields according to the requirements of your location.
2.
• Public Community Name (Default: public): The community string to allow the SNMP
manager to read the MIB objects of the WG102.
• Private Community Name (Default: private): The community string to allow the SNMP
manager to read and write the MIB objects of the WG102.
• Manager IP address: Enter the IP address of the SNMP manager. If this is set to
255.255.255.255, any SNMP manager will be allowed.
• IP address to Receive Traps: Enter the IP address of the SNMP manager to receive traps
sent from the wireless Access Point. If you don't want Traps to be sent, leave this at the
default value of 0.0.0.0
Be sure to click Apply to save your changes.
3.
Management
202-10064-02, June 2005
4-9