Configure The Wireless Access Point For Client Mode - NETGEAR ProSafe WNAP320 Reference Manual

Configure the Wireless Access Point for Client Mode

In client mode, the wireless access point operates as a client bridge only and sends all traffic
to the selected remote wireless access point or peer device.
To configure the wireless access point for client mode:
1. Select Configuration > Wireless Bridge. The Bridging screen displays:
Figure 60.
2. Select the Enable Wireless Bridging check box. The Local MAC Address field is a
nonconfigurable field that shows the MAC address of the wireless access point.
3. Select the Client radio button. (The Edit button becomes nonoperational after you have
selected the Client button.)
4. As an option, you can now enable MAC cloning, which allows only wireless connections to
computers or wireless stations for which you have added the MAC address to the
Trusted Wireless Stations table. For more information, see
MAC Address
To enable MAC cloning:
a. Next to MAC Clone, select the Enable radio button. By default, the Disable radio
button is selected.
b. In the MAC Clone Address field, enter the MAC address.
5. Click Apply to save your settings.
96 | Chapter 5. Advanced Configuration
ProSafe Wireless-N Access Point WNAP320 Reference Manual
on page 50.
Restrict Wireless Access by