Restore The Wireless Access Point To The Factory Default Settings - NETGEAR ProSafe WNAP320 Reference Manual

Restore the Wireless Access Point to the Factory Default
Settings
You can restore the wireless access point to the factory default settings by two methods that
are described in the following sections:
• Use the Web Management Interface to Restore Factory Default Settings
• Use the Reset Button to Restore Factory Default Settings
Note: After you have restored the factory default settings on the wireless
access point:
* All custom configurations will be lost.
* The login password will be password.
* The default LAN IP address will be 192.168.0.100.
* The DHCP client will be disabled.
* The Access Point Name field will be reset to the name printed on
the label on the bottom of the unit.
Use the Web Management Interface to Restore Factory Default Settings
IMPORTANT:
During the restoration process, do not try to go online, turn off the
wireless access point, shut down the computer, or do anything else
to the wireless access point until it finishes restarting!
To restore the factory default settings using the Web Management Interface:
1. Select Maintenance > Reset > Restore Defaults. The Restore Defaults screen
displays (see the following figure).
2. Select the Yes radio button. (By default, the No radio button is selected.)
3. Click Apply to reset the wireless access point to the factory default settings.
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about 1 minute. When the Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
62 | Chapter 4. Management
ProSafe Wireless-N Access Point WNAP320 Reference Manual
on this page
on page 63