NETGEAR ProSafe WNAP320 Reference Manual page 89

ProSafe Wireless-N Access Point WNAP320 Reference Manual
To configure a point-to-multipoint wireless network:
1. Configure the security profiles on the wireless access point (AP1 on LAN Segment 1 in
the previous figure):
a. Select Configuration > Wireless Bridge. The Bridging screen displays:
Figure 55.
b. Select the Enable Wireless Bridging check box. The Local MAC Address field is a
nonconfigurable field that shows the MAC address of the wireless access point.
c. Select the Wireless Point-to-Multi-Point Bridge radio button.
d. The profile table shows four security profiles. Choose a security profile to edit by
selecting the corresponding radio button to the left of the profile.
e. Click Edit to configure the selected security profile settings. The Edit Security Profile
screen displays for the selected security profile. (The following figure contains some
examples.)
Figure 56.
Chapter 5. Advanced Configuration | 89