Rear Panel; Bottom Panel With Product Label - NETGEAR ProSafe Premium WNDAP620 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620

Rear Panel

1
Figure 2.
The rear panel components of the wireless access point, from left to right, are described in
the following list:
1. First reverse SMA connector for an optional 2.4 GHz antenna.
2. Factory default Reset button. Using a sharp object, press and hold this button for about
5 seconds to reset the wireless access point to factory defaults settings. All configuration
settings are lost, and the default password is restored. For more information, see
the Wireless Access Point to the Factory Default Settings
3. 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with
IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router.
4. Second reverse SMA connector for an optional 2.4 GHz antenna.
5. Console port for connecting to an optional console terminal. The port has an RJ-45
connector and supports the following settings: 9600 K default baud rate, 8 data bits, no (N)
parity bit, and one (1) stop bit.
6. Cable security lock receptacle for an optional lock.
7. Power socket for a 12 VDC, 1.5A power adapter.
8. Third reverse SMA connector for an optional 2.4 GHz antenna.
Note: The wireless access point can support up to three optional 2.4 GHz
antennas.

Bottom Panel with Product Label

The product label on the bottom of the wireless access point's enclosure displays factory
default settings, regulatory compliance, and other information:
2
3 4
Introduction
13
7 8
5 6
on page 71.
Restore