Setting The Volume; Sound Settings; Calling Up The Sound Settings - Becker Cascade Operation Manual

Setting the volume

There are 50 volume settings. The vol-
ume setting applies to all radio and audio
sources.
You can specify whether changes in vol-
ume should be displayed in graphics for-
mat or not in "Displaying the volume"
on page 135.
! Turn the rotary control/push button
clockwise/counter clockwise.
1011
! The volume increases or decreases.
Note:
Subsequent sections of the operation
guide describe how to set the volume for:
• Traffic announcements (page Page 73)
• Navigation announcements and other
voice messages (Page 130)
• Acoustic signals (Page 135)

Sound settings

You can configure the sound of your
Cascade to meet your requirements in
the sound settings. The settings are also
valid for all radio/audio sources.

Calling up the sound settings

Press or until the sound
!
settings appear.
or
General operation
! Select Sound in the radio or Audio
main menu (Radio main menu
Page 62/Audio main menu Page 84).
1012
Turn the rotary control/push button
!
to select one of the following options:
Equačiser ,
Bačance / fader ,
Loudness
,
Becker surround ,
Subwoofer ,
Crossover ,
Compression and
Reset settings
Confirm your selection by pressing
!
the rotary control/push button
Note:
Press one of the buttons
, or in order to quit
the sound settings.
.
, ,
17