Table of Contents
Advertisement
Settings
7038
!
Enter the password by rotating/
pressing
the
rotary
control/push
button
.
Select the
symbol from the
!
input menu.
or
press the rotary control/push button
!
and hold for at least 2 seconds.
A connection will be established to the
required device. The device has now
been now authenticated.
If it was not possible to establish a
connection, the Cascade will notify you
of this on the display.
Note:
If a different device was already
connected, this will be disconnected.
124
Connecting a device (external device)
Connecting the Cascade to an external
device can also be initiated by the
external device.
Note:
If a device is already connected to
the Cascade, the attempt made by an
external device to establish another
hands-free connection will be ignored.
Two
different
scenarios
described below.
• The external device has previously
been connected to the Cascade.
• The external device has not been
connected to the Cascade before.
The external device has previously
been connected to the Cascade
Note:
If the function described in "Always
allow connection" auf Seite 121 is
activated, a short signal tone can be
heard and a message appears which
confirms that the external device has
been connected.
will
be
When the external device attempts to
establish a connection, a signal tone can
be heard and the following message
appears.
7039
!
Select between
•
Yes
Connection to the external device is
allowed.
No
•
Connection to the external device is
rejected.
Yes
No
Ačways
,
and
.
Advertisement
Table of Contents
