Standby Timer - Barco CineVERSUM 110 R9010120 Owner's Manual

7. General Menu
How to freeze the image ?
1. Press MENU to activate the menu bar.
2. Press → to select General.
3. Press ↓ to pull down the General menu.
4. Use ↑ or ↓ to select Freeze. (image 7-2)
5. Press ENTER to activate the Freeze function.
Image 7-2
The image can also be frozen using the FREEZE key on the RCU.

7.4 Standby Timer

Purpose of the Standby Timer
If there is no signal, and the standby timer is enabled, a dialog box is displayed and the projector will shut down after a determined
time.
Message
No signal available
Projector will go to standby
Press <BACK> to cancel
Image 7-3
The countdown time can be set in a dialog box in a range from 180 to 3600 seconds (default value = 300). The Timer can also be
disabled.
How to enable the standby timer ?
1. Press MENU to activate the menu bar.
2. Press → to select General.
3. Press ↓ to pull down the General menu.
4. Use ↑ or ↓ to select Standby Timer. (image 7-4)
5. Press ENTER to activate the function.
On the screen appears a dialog box. (image 7-5)
6. Use ↑ or ↓ to select Enabled .
A box surrounds the selected item.
7. Press ENTER to activate.
8. Use ↑ or ↓ to browse to the input field.
9. Use ← or → , the numeric keys on the remote or the keypad to change the countdown setting.
10.Press MENU or BACK to exit or to go back to the previous menu.
50
1:20
R5976697 CINEVERSUM™ 110 06012004