Mode - Barco CineVERSUM 110 R9010120 Owner's Manual

11. Lamps Menu

11.3 Mode

Single lamp mode
The projector will always switch to the lamp with the shortest runtime when the difference between the runtimes of lamp 1 and lamp
2 reaches 100 hours, switching from one lamp to another happens only at switching on of the projector and not during operation.
When the lamp fails or reaches its maximum runtime the projector switches automatically to the other lamp without interrupting the
projection. The failure is logged and the lamp will never be initialized in the future.
Image 11-3
Single mode operation: switching principle
Dual lamp mode
Both lamps are working.
When one lamp fails, the projector continues the projection using the remaining lamp.
How to select the lamp mode ?
1. Press MENU to activate the menu bar.
2. Press → to select the Lamps item. (image 11-4)
3. Press ↓ to pull down the Lamps menu.
4. Use ↑ or ↓ to select Mode.
5. Press → to pull down the menu.
6. Use ↑ or ↓ to select the desired mode.
Single Only one lamp is ignited.
Dual Both lamps are ignited.
7. Press ENTER to confirm.
A bullet shows the active mode.
88 R5976697 CINEVERSUM™ 110 06012004